I recently bought a 2001 TA WS6 as a project for my son.
Initially, the drive turning signals worked; they just flashed super slow.
Passengers' sides stay solid.
I went out today to replace the low beam headlight on the passenger side and noticed that both driver and passenger side turning signals were staying solid.
I did some digging and saw where the flasher relay could be an issue, so I pulled the knee panel off and saw that the harness was taped up, and after wiggling it around, the driver's side started working again.
From what I can tell, there are only two wires.
Initially, the drive turning signals worked; they just flashed super slow.
Passengers' sides stay solid.
I went out today to replace the low beam headlight on the passenger side and noticed that both driver and passenger side turning signals were staying solid.
I did some digging and saw where the flasher relay could be an issue, so I pulled the knee panel off and saw that the harness was taped up, and after wiggling it around, the driver's side started working again.
From what I can tell, there are only two wires.