• Welcome to the Pontiac Trans Am Community, the Official Home of the PTA! Sign up for a (FREE) account today!

Search results

  1. P

    4L60E?

    So, I put a pry bar between the mount and the tail shaft. Tranny was moving a good 1/4-3/8 of an inch. Does that seem like too much movement?
  2. P

    4L60E?

    I will check that next and follow up. Thanks
  3. P

    4L60E?

    Hello all, I have an 02 WS6 that clunks when you step on the gas after a 3-2 down shift during a rolling turn. I have checked the U-joints, and they seem fine. There is nothing loose underneath. Once it goes back to 3rd clunking stops. Any ideas where to look?
  4. P

    Knock Sensor Connector Location?

    I have a 2002 WS6 with a 5.7L.
  5. P

    Knock Sensor Connector Location?

    Hi all. Does anyone know if the knock sensor connector to the ecm is accessible without removing the intake?
  6. P

    2002 Trans Am WS6 Rear Clunk?

    Hello all, I have a 2002 WS6 with a four-speed auto trans. That clunk comes from the rear when stepping on the gas after or during a left turn; otherwise, there is no noise. This winter, there was alot of work done, UMI sway bar, subframe connectors, and tunnel mount torque arm. The...
  7. P

    Rear Pinion Yoke?

    2002 WS6.
  8. P

    Rear Pinion Yoke?

    Does anyone know the purpose of the rubber piece attached to the yoke? Is it a dust cover to protect the seal? Thanks ahead of time.
  9. P

    Caliper Bracket?

    Here it is.
  10. P

    Caliper Bracket?

    Hi Everyone, I have a 02 WS6, and trying to restore it to the original. Does anyone know what the finish should be on the rear caliper bracket? Clear zinc, yellow zinc plated, or natural?
  11. P

    Chewed Wires - 2002 Trans Am WS6

    Letters are HCFE is all I can see.
  12. P

    Chewed Wires - 2002 Trans Am WS6

    Hello all. I have a 2002 WS6 and a connector that has chewed wires. Can anybody identify this 8-pin connector in front of the ECM on the drinker's side?