Hello all,
I have a 2002 WS6 with a four-speed auto trans.
That clunk comes from the rear when stepping on the gas after or during a left turn; otherwise, there is no noise.
This winter, there was alot of work done, UMI sway bar, subframe connectors, and tunnel mount torque arm.
The pinion seal, axles, bearings, and seals were all replaced.
Another issue is a vibration when it shifts into overdrive.
The overdrive issue was before all the other work was done.
Looking for some direction; any help is appreciated.
I have a 2002 WS6 with a four-speed auto trans.
That clunk comes from the rear when stepping on the gas after or during a left turn; otherwise, there is no noise.
This winter, there was alot of work done, UMI sway bar, subframe connectors, and tunnel mount torque arm.
The pinion seal, axles, bearings, and seals were all replaced.
Another issue is a vibration when it shifts into overdrive.
The overdrive issue was before all the other work was done.
Looking for some direction; any help is appreciated.
